Ce-niehoff-co C102/C102-1 Installation Manual do Utilizador descarregar pdf

II128A

Page 1 of 2

C102/C102-1 Alternators

Installation Instructions

1. MOUNT FAN AND PULLEY (Figure A).

2. MOUNT AND CONNECT REGULATOR (Figures B and C).

Torque to 50 ft. lbs. using locknut and hardened washer (A1)

supplied on alternator shaft.

Position regulator plug and secure regulator with screws (B1)

provided in regulator package. Regulator plug must be securely

held in place by regulator (B2).

Connect alternator plug to regulator plug (C1).

3. POSITION GROUND LINK (Figure C).

Units are shipped with the ground link installed for negative

ground as shown (C2). Reverse connections for positive ground

as indicated by dotted line (C3).

4. INSTALL ALTERNATOR (Figure A).

Attach belt adjusting bracket with bolt (A2) included in parts

package.

Insert mounting bolt and hand tighten nut (A3). Bolt should be

new and SAE Grade 5 or better. Nut should be self locking or

coated with "Loctite Lock and Seal" or equivalent.

5. SET BELT TENSION (Figure A).

On engines where the belt drives only the alternator, use a belt

tension gauge and set tension at 40 to 50 lbs. New belts should

be set at 75 lbs. On engines where the belt also drives other ac-

cessories, consult manufacturer's speciﬁ cations. If belt tension

gauge is not available, set tension so that the fan cannot be turned

by hand. CAUTION: DO NOT SET TENSION TOO HIGH AS

THIS WILL CAUSE PREMATURE BEARING FAILURE.

Tighten bolt (A2) on belt adjusting bracket. Torque to 17 ft. lbs.

Tighten mounting bolt (A3). Torque to 35 ft. lbs.

WIRING

CAUTION: Connecting the alternator improperly can cause serious damage.

1. For negative ground systems, connect existing battery wire to "BAT+" (D1) on alternator. For positive ground systems, connect battery wire

to "BAT-" on alternator. Be sure ground link is positioned correctly (C2 or C3).

2. On negative ground applications where a warning light is used, connect wire from "R" (D2) terminal on the alternator to the A2-250 relay

(D3).

NOTE: For isolated ground applications, discard the ground link. Attach both the positive and negative leads directly to the alternator.

INSTALLATION

1 2

Resumo do Conteúdo

Página 1 - C102/C102-1 Alternators

II128APage 1 of 2C102/C102-1 AlternatorsInstallation Instructions1. MOUNT FAN AND PULLEY (Figure A).2. MOUNT AND CONNECT REGULATOR (Figures B and C).T

Página 2 - TROUBLE SHOOTING

C. E. Niehoff & Co. • 2021 Lee Street • Evanston, IL 60202 Tech Services Hotline 800-

Comentários a estes Manuais

Sem comentários

Ce-niehoff-co C102/C102-1 Installation Manual do Utilizador

Consulte online ou descarregue Manual do Utilizador para Hardware Ce-niehoff-co C102/C102-1 Installation. C.E. Niehoff & Co. C102/C102-1 Installation User Manual Manual do Utilizador

Resumo do Conteúdo

Comentários a estes Manuais

Manuais e produtos relacionados com Hardware Ce-niehoff-co C102/C102-1 Installation