Ce-niehoff-co N1387 Alternator/EPM Operating Reference Card Manual do Utilizador

Consulte online ou descarregue Manual do Utilizador para Hardware Ce-niehoff-co N1387 Alternator/EPM Operating Reference Card. C.E. Niehoff & Co. N1387 Alternator/EPM Operating Reference Card User Manual Manual do Utilizador

  • Descarregar
  • Adicionar aos meus manuais
  • Imprimir
  • Página
    / 2
  • Índice
  • MARCADORES
  • Avaliado. / 5. Com base em avaliações de clientes
Vista de página 0
Table 1 – Vehicle Operating Instructions
Normal Start-Up
1. Press vehicle battery-connect button to connect batteries.
2. Turn START-RUN switch to RUN position.
3. Wait until glow plug light goes off.
4. Turn START-RUN switch to START position and crank engine.
5. Return switch to RUN position when engine starts.
6. If engine fails to crank, turn START-RUN switch to OFF position, repeat steps 1-5.
7. If engine still fails to start, the EPM could be damaged.
Shutdown Procedure
1. Place gear shift in park or neutral and set parking brake.
2. Turn START-RUN switch to OFF position to stop engine.
3. Batteries will be disconnected from vehicle in 3 minutes
unless emergency flashers are on, then batteries will stay
connected until flashers are turned off or battery is
discharged.
II0041A Side 1 of 2
Do not press battery-connect button on vehicle when START-RUN
switch is in RUN position.
1. Connect slave vehicle Nato connector to vehicle.
2. Follow steps 2-5 above.
3. Disconnect slave NATO connector after engine is running.
This procedure will bypass EPM and batteries in system. Use this
procedure ONLY when vehicle must be removed immediately from
location in an EMERGENCY.
a. Remove cables from “Load” side of EPM and temporarily attach to “Battery” side
of EPM.
b. Follow steps 2-5 above.
CAUTION
WARNING
Do not leave vehicle cabling connected as described in steps 7a-b.
Diagnostic and repair must be performed as soon as possible.
WARNING
Emergency Start-Up
Vista de página 0
1 2

Resumo do Conteúdo

Página 1 - Emergency Start-Up

Table 1 – Vehicle Operating InstructionsNormal Start-Up1. Press vehicle battery-connect button to connect batteries.2. Turn START-RUN switch to RUN po

Página 2 - AMBER

N3225 LEDs COLOR N3225 STATUSTABLE 2 – N3225 Regulator LEDs DiagnosticsRegulator is not energized. Measure IGN terminal voltage.If voltage is above 21

Comentários a estes Manuais

Sem comentários